Installation Instructions

WiBAS / WiBAS G5 Base Stations
Installation & Cabling Manual - Edition 3.2
241
POE-HP-OD67-DC
Introduction
Apply this procedure for installing the outdoor DC power injector PONE-HP-
OD67-DC.
Power injector
details
Characteristics:
 DC POE injector
 outdoor-IP67 class
 114 watt
 Wall mount
 temperature hardened
 operating temperatures -40° C to +55° C
 DC voltage (V DC)
 Input nominal: 48
 Min: 40.5
 Max: 57
 DC current (A):
 Input: 3
 Output: 2
Packing List:
 Ethernet cable glands are pre-installed on the unit (current sharing on all
four pairs of Ethernet cable).
 Grounding screw is pre-installed on the unit.
 DC Power connector is included in the package.
 Screws, washers and wall plugs are included in the package (for wall
installation).
 For pole installation, a mounting bracket (INSTPONE-PL2) should be
ordered.
 For grounding, a grounding kit (GND-KIT16-OD) should be ordered.
 For powering, a DC power cable (DC-PWR-CAB-1 or DC-PWR-
CAB-3) should be ordered.
 Applicable Ethernet cable: S-FTP (Cat5E or Cat6) with shielded RJ-
45 plugs.
 Lightning surge protection is embedded in the unit.
Continued on next page