Installation Instructions

Appendix A - Installing Power Injectors

236

PONE-OD-DC, Continued

Procedure

How to install the PONE-OD-DC onto the pole or wall, proceed as follows:

Step

Action

For pole installation follow this step. For wall installation go to

last step.

Perform the following actions:

 Attach the plate onto rear side of PONE, as shown below (A).

 Install lock washer and screw. Then use the cross headed

screwdriver to fully tighten (B).

 Pass the hose clamp through the plate holes (C).

 Install the PONE onto pole. Use the tool with M5 deep socket

to tighten (D).

Do not over tighten. Use the tool with TORX T10 bit for

max tightening torque 2 Nm.

 Use the tool with TORX T10 bit to remove the six screws (E).

Then detach the PONE cover for installing the cables. Be

careful not to drop the screws while removing.

Continued on next page