Installation Instructions

WiBAS / WiBAS G5 Base Stations

Installation & Cabling Manual - Edition 3.2

229

PONE-OD67-AC, Continued

Procedure,

continued

Step

Action

Perform the following actions:

 Insert the claw to body taking in consideration the caution

below (A).

 Insert the seal to claw (B).

 Use the adjustable torque U-wrench to screw the sealing nut

to body (C).

Do not over tighten. Adjust the tool for maximum

tightening torque 6 Nm.

Take care when you unplug the RJ-45 jack. The latter is

locked into the mating receptacle and must be extracted

first (with the tip of a flat-headed screwdriver) after

removing the gland parts from the lower part of PONE.

Continued on next page