Installation Instructions

WiBAS / WiBAS G5 Base Stations
Installation & Cabling Manual - Edition 3.2
209
Cable Holder, Continued
Procedure for
WiBAS OSDR-
HUB
How to install the cable holder to WiBAS
TM
OSDR-HUB, proceed as
follows:
Step
Action
1
Use the allen key to remove the three screws with lock
washers, as shown below.
2
Perform the following actions:
 Mount the holder to radio (A).
 Install the three lock washers and screws (B), as shown
below:
 Use the wrench tool to tighten the screws.
Do not over tighten. Adjust the tool for applying maximum
tightening torque 2 Nm.
Continued on next page