Installation Instructions

WiBAS / WiBAS G5 Base Stations
Installation & Cabling Manual - Edition 3.2
203
Fiber Optic Cable, Continued
Procedure for
WiBAS G5
dual-BS,
continued
Step
Action
6
Install the M20 thread extension, as shown below:
Use the adjustable torque U-wrench to tighten.
Do not over tighten. Adjust the tool for max tightening
torque 6 Nm.
7
Install the remaining parts of the gland, as follows:
 Install the body (M20 thread).
 Do not over tighten. Adjust the tool for max tightening
torque 5 Nm.
 Insert claw into the body (M20 thread).
Align the designated points. Misaligning of parts will
cause damage.
 Insert the blue seal into “pressure fingers” of claw.
 Position the spacer (only for metallic gland).
 Screw the sealing nut. Use the adjustable torque U-wrench to
fully tighten.
Continued on next page