Installation Instructions

WiBAS / WiBAS G5 Base Stations
Installation & Cabling Manual - Edition 3.2
191
ETH Cable, Continued
Procedure for
WiBAS G5
dual-BS,
continued
Step
Action
7
Install the cable holder (refer Procedure for WiBAS G5 dual-
BS).
Take care when you unplug the RJ-45 jack.
The RJ45 jack is locked into the mating receptacle.
Do not remove the Body part of the gland.
Take care when you unplug the RJ-45 jack. The jack is locked
into the mating receptacle. After removing the seal and claw use
the flat side of the extruder (or a screwdriver) to extract the RJ-
45 jack by pressing the locking clip upwards, as shown below.
End of procedure.