Installation Instructions

4. Installation Procedures
96
WiBAS-Connect Combo, Continued
Procedure for
WiBAS-
Connect (auto-
polarization)
Combo,
continued
Step
Action
10
Set the antenna position, as shown in step 3.
11
Mount the elevation bracket onto the radio and then install the
respective set of mounting kit packing materials, as shown in
step-4.
Do not over tighten the screws. Adjust the tool for
applying max tightening torque 5.5 Nm for M5 screws.
12
Mount the elevation bracket onto the azimuth bracket and then
install the respective set of mounting kit packing materials, as
shown in step-5.
Do not over tighten the screws. Adjust the tool for
applying max tightening torque 15 Nm.
13
The wall mount installation should appear, as shown below:
For cables installation refer to Installing Radio Units Cables .
End of procedure for wall mount installation.
End of procedure.