Installation Instructions

WiBAS / WiBAS G5 Terminal Stations

Installation & Cabling Manual - Edition 2.1

WiBAS-Connect Combo, Continued

Procedure for

WiBAS-

Connect (auto-

polarization)

Combo,

continued

Step

Action

Mount the elevation bracket onto the azimuth bracket and then

install the respective set of mounting kit packing materials, as

shown below:

Do not over tighten the screws. Adjust the tool for

applying max tightening torque 15 Nm.

For cables installation refer to Installing Radio Units Cables .

End of procedure for pole mount installation.

Perform the following actions:

 Mark with a pencil the holes in the wall surface.

 Use the drilling machine (fitted with a 13 mm drill bit) to open

the respective holes.

Continued on next page