Installation Instructions

WiBAS / WiBAS G5 Terminal Stations

Installation & Cabling Manual - Edition 2.1

Statement: Information to the User, Continued

WiBAS G5 Connect+

(auto polarization)

WiBAS-Connect

(auto-polarization)

Class B equipment

FCC Part 15.19 Statement: Information to the User

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including

interference that may cause undesired operation.

FCC Part 15.21 Statement: Information to the User

Changes or modifications made to this equipment, not expressly

approved by the party responsible for compliance, could void the user's

authority to operate the equipment.

FCC Part 15.105 Statement: Information to the User

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to

radio communications.

However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for

an uncontrolled environment. This transmitter must not be co-located or

operating in conjunction with any other antenna or transmitter. In order

to avoid the possibility of exceeding the FCC radio frequency exposure

limits, this equipment should be installed and operated with minimum

distance 440 cm between the antenna and your body during normal

operation. Users must follow the specific operating instructions for

satisfying RF exposure compliance.

Continued on next page