Installation Instructions

WiBAS / WiBAS G5 Terminal Stations
Installation & Cabling Manual - Edition 2.1
61
3.4. Recommended Installation Tools
Introduction
This section describes all the recommended tools for installation of
WiBAS
TM
Terminal Stations.
Prerequisites
It is installer responsibility to provide the tools for equipment installation.
Equipment
installation
tools
Item
Tool / Photo
Description
1
Adjustable torque U-wrench tool (up to 29
mm opening and supporting max
tightening torque 40 Nm).
Used for tightening screws and nuts.
2
Adjustable torque wrench tool with bits
(supporting max tightening torque 20 Nm).
Used for tightening screws and nuts.
3
Set of allen keys.
Used for WiBAS
TM
OSDR-TS radio unit
polarization change (1.5 mm) and cable
holder installation (2.5 mm).
4
Cross head and Flat head slotted tip
screwdrivers (PH2 / PH3).
Used for general works.
Continued on next page