Installation Instructions

WiBAS / WiBAS G5 Terminal Stations
Installation & Cabling Manual - Edition 2.1
197
PONE-OD-DC, Continued
Procedure,
continued
Step
Action
6
For wall installation perform the following actions:
 Use the tool with TORX T10 bit to remove the six screws (A).
 Then:
 Position the device on the wall surface and using a pencil
mark the drill points (B). With the drill machine (fitted with 5
mm bit), drill four holes on the wall surface, at a depth of 45
mm.
 Install the four supplied wall plugs and using the cross
headed screwdriver and tighten the four screws.
End of procedure.