Installation Instructions

Appendix A - Installing Power Injectors

194

PONE-OD-DC, Continued

Procedure,

continued

Step

Action

Perform the following actions for installing the Ethernet (S-

FTP) cables:

 Use the tool with TORX T10 bit to remove (A) the clamp

screw. Be careful not to drop the screw while removing.

 Plug (B) the Ethernet cables to the Gbe receptacles (OUT:

goes to radio unit and IN: goes to customer network). Listen

for a “click” when inserting. This verifies that the jack has

been inserted properly.

The shielded wires should protrude from clamp about 0.5

cm (as shown below).

 Use the tool with TORX T10 bit to install the clamp (C) for

securing the cables in place.

Do not over tighten. Adjust the tool for max tightening

torque 0.9 Nm.

Continued on next page