Installation Instructions

WiBAS / WiBAS G5 Terminal Stations
Installation & Cabling Manual - Edition 2.1
193
PONE-OD-DC, Continued
Procedure
How to install the PONE-OD-DC onto the pole or wall, proceed as follows:
Step
Action
1
For pole installation follow this step. For wall installation go to
last step.
Perform the following actions:
 Attach the plate onto rear side of PONE, as shown below (A).
 Install lock washer and screw. Then use the cross headed
screwdriver to fully tighten (B).
 Pass the hose clamp through the plate holes (C).
 Install the PONE onto pole. Use the tool with M5 deep socket
to tighten (D).
Do not over tighten. Use the tool with TORX T10 bit for
max tightening torque 2 Nm.
 Use the tool with TORX T10 bit to remove the six screws (E).
Then detach the PONE cover for installing the cables. Be
careful not to drop the screws while removing.
Continued on next page