Installation Instructions

WiBAS / WiBAS G5 Terminal Stations
Installation & Cabling Manual - Edition 2.1
171
Cable Holder, Continued
Procedure
How to install the cable holder to WiBAS
TM
OSDR-TS radio unit, proceed as
follows:
Step
Action
1
Use the wrench tool to remove the three screws with lock
washers, as shown below.
2
Perform the following actions:
 Mount the holder to radio (A).
 Use the wrench tool to install the three lock washers and
screws (B), as shown below:
Do not over tighten. Adjust the tool for applying maximum
tightening torque 2 Nm.
Continued on next page