Manualshelf

Installation Instructions

ManualsBrandsINTRACOM ManualsElectronicsPtMP/PtP Gigabit Terminal Radio 27-29 GHz
51525354555657585960
4. Installation Procedures
160
Grounding Cable, Continued
Procedure for
WiBAS-
Connect (both
editions)
How to install the grounding cable to radio units (CONN-OB-U-DSDS /
CONN-OB-U-DSDS-DP), proceed as follows:
Step
Action
1
If the terminal lug is installed then follow this step. If the terminal
lug is not installed then follow step 2.
Use the tool to remove the pre-installed M5 grounding terminal.
2
Perform the following actions:
Install the cable, as shown below.
Use the tool with M5 hexagon female bit to fully tighten the
screw.
Do not over tighten the M5 nut. Adjust the tool for
applying maximum tightening torque 4.2 Nm.
DO NOT forget to install the other end of the grounding
cable to grounding bar.
End of procedure.
Continued on next page