Installation Instructions

4. Installation Procedures

152

WiBAS OSDR-TS and Panel, Continued

Procedure,

continued

Step

Action

Radio unit and antenna should be adjusted for common

polarization. If the LINK polarization is HORIZONTAL then the

feeders should be remained, as shown below:

If the LINK polarization is VERTICAL, use the allen key to

loosen the four screws at the waveguide port of the radio (do

not remove the screws) and then TURN the polarizer, as

shown below:

The terminal station polarization at 10.5 GHz (radio-panel

antenna) is specific and applicable to this case only.

Do not over tighten the screws. Apply maximum tightening

torque 0.6 Nm.

The misalignment of slots between the movable part and the

stationary part of the radio waveguide port is intentional and

does not indicate a problem.

Continued on next page