Installation Instructions

4. Installation Procedures
120
WiBAS-Connect and Parabolic 0.3 m with Adaptation Plate /
0.6 m with Clamps, Continued
Procedure
using 0.3 m
antenna and
adaptation
plate
How to install WiBAS
TM
-Connect (CONN-OB-U-DSDS) to 0.3 m antenna
(ANT-IS-26-1F) with adaptation plate (WCONN-PAR-ANT-KIT), proceed as
follows:
Step
Action
1
Remove antenna protection label from the feeder, as shown
below.
2
Radio unit and antenna should be adjusted for common
polarization, as shown below. If the LINK polarization is
VERTICAL then the feeders should be remained, as shown
below (radio unit – both sides view):
If the LINK polarization is HORIZONTAL, rotate the radio unit
and antenna feeder, as shown below (radio unit – both sides
view):
How to change antenna polarization refer to antenna
installation leaflet.
Continued on next page