Installation Instructions

Appendix B – Terminating Cables
212
Power
Introduction
Apply this procedure for terminating the following power supply cables:
 AC cable for PONE-OD67-AC:
 AC-PWR-CAB (3 x 0.75 mm
2
)
 DC cables for POE-HP-OD67-DC:
 DC-PWR-CAB-1 (2 x 1 mm
2
)
 DC-PWR-CAB-3 (2 x 2.5 mm
2
)
For DC cable termination ((DC-PWR-CAB-2 (2 x 2.5 mm
2
)) of PONE-
OD-DC refer to Procedure on page 193.
Termination
overview
The pictures below shows a termination overview of power supply cable to
the respective connector:
Tools and
materials
Tools
 Blade, cable cutter, soldering iron, solder (refer to Termination
of cables).
Materials
 AC-PWR-CAB
 DC-PWR-CAB-1 or DC-PWR-CAB-3
 PONE-OD67-AC
 POE-HP-OD67-DC
Continued on next page