Installation Instructions

Appendix B – Terminating Cables

210

Grounding, Continued

Tools and

materials

Tools

 Blade, cable cutter, crimping tool for 6 mm

and 16 mm

grounding cable and hot air gun (refer to Termination of

cables).

Materials

 GND-KIT16-OD (16 mm

cable)

 GND-CAB6-ID (6 mm

cable)

Procedure

How to terminate the 16 mm

grounding cable to GND-KIT16-OD lugs,

proceed as follows:

Step

Action

Cut the grounding cable according to the distance between

equipment and grounding bar.

Use the blade to strip 1 cm from each end of the cable, as

below:

Perform the following actions:

 Slide the M5 grounding lug over the wires at one end of the

cable and crimp it with the special crimping tool.

 Cut the heat shrinkable tube in the middle in two equal

pieces in order to use one piece per cable side.

 Slide the one piece of the heat shrinkable tube over the

cable. Heat it over rear grounding ring body and down on

to cable jacket using the hot air blower.

Repeat step 3 for the other end of the cable in order to

terminate the M8 grounding lug.

End of procedure.

Continued on next page

1 cm