Users Manual

6. Equipment Commissioning
84
Service Provisioning, Continued
Procedure, continued
Step Task
WiBAS-OSDR Node Manager
Manual
Concerns to WiBAS
TM
…
Hub TS Connect
7
Bridge
How to configure the bridge refer
to chapter 6/6.2, paragraph
“Configuring the Bridge”.
√ √ √
8
L2 Ports
How to configure the L2 ports
refer to Chapter 6/6.2, paragraph
“Configuring the L2 Ports”.
√ √ √
9
VLANs / VLAN
Ports
How to add VLANs / VLAN ports
refer to Chapter 6/6.2, paragraph
“Adding VLANs / VLAN Ports”.
√ √ √
10
L2CP
How to configure L2CP refer to
Chapter 6/6.2, paragraph
“Configuring L2CP”.
√ √ √
11
Bandwidth
Profile
How to add a bandwidth profile
refer to Chapter 6/6.3, paragraph
“Adding a Bandwidth Profile”.
√ √ √
12
Ethernet CoS
Flow
How to add an Ethernet CoS flow
profile refer to Chapter 6/6.3,
paragraph “Adding an Ethernet
CoS Flow”.
√ √ √
13
Synchronization
(QL Mode e.t.c).
How to configure the
synchronization refer to Chapter
6/6.4, paragraph “Configuring
SyncE”.
√ √ -
14
Backup
configuration
Log in to base station and
terminal station and go to
Maintenance & Troubleshoot >
Maintenance.
Click on the backup tab, as shown
below
and save the file with tar
extension.
√ √ √
End of procedure.