Users Manual

6. Equipment Commissioning
82
Checking Operation, Continued
Terminal
station
procedure
This paragraph describes how to check the WiBAS
TM
-OSDR TS or
WiBAS
TM
-Connect operation (taking in consideration that all commissioning
works have been completed successfully):
Step
Action
1 Communicate with terminal station through inband.
2 Go to Equipment Management > Radio and check the status as
shown below:
Go to
Equipment Management
> Modem
and check the status.
3 Go to Summary > Terminals and check the values of the
following:
• Connectivity: connected
• Physical Mode (UL & DL): “based on the radio planning data”
• RSSI: “based on the radio planning data”
• SNR: “based on the system expected data”
4 Go to Alarm List and check if active alarms exist (without
preventing system operation).
5
Go to Service Provisioning and check if the values of the following
are the expected ones:
• Bridge
• Ethernet CoS Flow
• Synchronization
(1)
End of procedure.
(1)
Synchronization is related to WiBAS-OSDR TS only.