Users Manual

6. Equipment Commissioning

WiBAS-Connect TS (Auto-Polarization Edition)

, Continued

Procedure for WiBAS-Connect Auto-Polarization TS with Parabolic Low Profile

Antenna, continued

Step Action

2 Perform coarse alignment, as follows:

Use the respective spanner key to rotate the assembly on the pole so that the

antenna is “visually” aligned with the target base station sector.

 Use compass and binoculars for alignment.

 Use the RF planning values for aligning the assembly to the target base

station sector.

 Use the adjustable U-Wrench to apply the final tightening torque (M8 u-

bolts nuts max tightening torque 15 Nm).

 U-Bolt fully tightening. Do not over tighten. Overtightening will cause

deformation of the support clamp.

Continued on next page