Users Manual

WiBAS OSDR-Hub & Terminal Station / WiBAS-Connect Terminal Station
Start Up & Commissioning Manual - Edition 5.1
71
WiBAS-Connect TS (Auto-Polarization Edition), Continued
Procedure for
WiBAS-
Connect Auto-
Polarization TS
with Parabolic
Low Profile
Antenna
To perform WiBAS
TM
-Connect auto-polarization radio unit TS parabolic low
profile antenna alignment, please follow the steps below:
This procedure is performed for Auto-Polarization Edition radio unit.
The factory default polarization for dual polarization terminals is V.
It is assumed that WiBAS-Connect TS has dual frequencies configured.
The TS polarity is identified via voltmeter value, as follows:
• In vertical polarity the voltmeter shows 0.X, where X is the QI value.
• In horizontal polarity the voltmeter shows 1.X, where X is the QI
value.
• During polarity change the voltmeter shows ~2.5 V and no action
should be performed.
For QI values please refer to QI table on page 93
.
Continued on next page