Users Manual

6. Equipment Commissioning

WiBAS-Connect TS, Continued

Procedure for WiBAS-Connect TS with Panel Antenna, continued

Step Action

3 Perform fine alignment, as follows:

• Use the spanner key to loosen the azimuth adjustment bolts (A). Perform azimuth

adjustment by moving very slowly the whole system (within the ±10

range around

the azimuth axis)

until the voltage readout reaches a desired level.

• Use the spanner key to loosen the elevation adjustment bolts (E). Perform

elevation adjustment by moving very slowly the whole system (within the ±10

range around the elevation axis) until the voltage readout reaches a desired value.

• (A) = Azimuth bolts x 2 (up and down)

• (E) = Elevation bolts x 2 (left and right).

The RSSI voltage (actually the voltmeter value) provides a direct

relationship with RSL.

For WiBAS-OSDR see

WiBAS-OSDR terminal station RSSI measurement

calculation formula on page 41,

For WiBAS-Connect see

WiBAS-Connect terminal station RSSI

measurement calculation formula on page 41).

4 Use the adjustable torque wrench for pre-tightening. The final tightening torque

will be applied after alignment process completion.

Continued on next page