Users Manual

4. Installation Procedures

Panel Antenna, Continued

Panel antenna installation procedure, continued

Step Action

2 Radio unit and antenna should be adjusted for common polarization. If the LINK

polarization is HORIZONTAL then the feeders should be remained, as shown

below:

If the LINK polarization is VERTICAL, use the allen key to loosen the four screws

at the waveguide port of the radio (do not remove the screws) and then TURN the

polarizer, as shown below:

The terminal station polarization at 10.5 GHz (radio-panel antenna) is specific and

applicable to this case only.

Do not over tighten the screws. Apply maximum tightening torque 0.6 Nm.

The misalignment of slots between the movable part and the stationary part of the radio

waveguide port is intentional and does not indicate a problem.

Continued on next page