Users Manual

Appendix C: Power Injector Installation
104
Outdoor DC PoNE, Continued
Pole and wall installation procedure, continued
Step Action
4
Switch-off the local DC power source & the circuit breaker (between PoNE
and the local DC power source).
Install the power supply cable, as follows:
A:
Connect the power cable to the local DC power source (Brown wire: +V, blue
wire: -V).
B:
At the other end of the cable, use a blade to strip the wires of the cable, as
shown below. Twist strands well to facilitate their insertion into the INPUT
receptacle of DC PonE device.
C:
Use the tool with TORX T10 bit to remove the clamp and insert the bare ends
of the cable into the corresponding positions of the INPUT receptacle, as
shown below:
Blue wire to INPUT -, Brown wire to INPUT +.
D: Use the flat-headed screwdriver to tighten the INPUT receptacle screws. Do
not over tighten. The screws, securing the wire strands into the receptacle,
are well isolated each other – no danger for accidental short circuit.
D:
Use the tool with TORX T10 bit to install the clamp in order to secure the DC
power supply cable.
Do not over tighten. Adjust the tool for max tightening torque 0.9 Nm.
End of procedure.