Users Manual

Appendix C: Power Injector Installation
102
Outdoor DC PoNE, Continued
Pole and wall installation procedure, continued
Step Action
2
Prepare and terminate the Ethernet cables (x 2) as instructed to Appendix D: Cables
Termination on page 114.
Install the Ethernet cables, as follows:
A: Use the tool with TORX T10 bit to remove the clamp screw. Be careful not to
drop the screw while removing.
B:
Plug the Ethernet cables to the Gbe receptacles (OUT: goes to radio unit and
IN: goes to customer network). Listen for a “click” when inserting. This
verifies that the jack has been inserted properly.
The shielded wires should protrude from clamp about 0.5 cm (as shown
below).
C:
Use the tool with TORX T10 bit to install the clamp for securing the cables in
place.
Do not over tighten. Adjust the tool for max tightening torque 0.9 Nm.
Continued on next page