Installation Manual

StreetNode™ 6250 PTP
Installation & Cabling Manual - Edition 2.1
7
List of Materials, Continued
Power cables
The following table shows the power cables:
Item
Order Code / Photo
Description
A
AC-PWR-CAB
AC power bulk cable, 3 x 0.75 mm
2
, 0.6 / 1 kV,
stranded, UV-rated, industrial type, for outdoor
use (per meter)
(1)
(for distance between StreetNode
TM
6250 PTP
and local power source < 300 m).
B
ST-AC-CAB10
AC power pre-fabricated cable, 10 m,
terminated at radio unit side only (with ST-
CONN-AC connector), 3 x 0.75 mm
2
, 0.6 / 1 kV,
stranded, UV-rated, industrial type, for outdoor
use.
Limited quantities for use in trials.
C
DC-PWR-CAB-1
DC power bulk cable, 2 x 1 mm
2
, 0.6 / 1 kV,
stranded, UV-rated, industrial, for outdoor use
(per meter)
(2)
(for distance between StreetNode
TM
6250 PTP
and local power source < 100 m).
D
ST-DC-CAB1
DC power pre-fabricated cable, 1 m, terminated
at radio unit side only (with ST-CONN-DC
connector), 2 x 1 mm
2
, 0.6 / 1 kV, stranded, UV-
rated, industrial type, for outdoor use.
Limited quantities for use in trials.
E
DC-PWR-CAB-2
DC power cable, 2 x 2.5 mm
2
, PVC, 1KV, for
outdoor use (per meter).
The following cable is used for:
• Direct DC powering of StreetNode
TM
6250 PTP
when distance from the local DC power supply
source is from 100 m to 300 m
(3)
Connecting the power injector (if existing) with
the local DC power supply source (StreetNode
TM
6250 PTP)
Continued on next page
(1)
The ST-CONN-AC connector required for the cable termination is included in the radio equipment package.
(2)
The ST-CONN-DC connector required for the cable termination is included in the radio equipment package.
(3)
In this case, connection to the radio unit connector is via a short cable tail made with the 2 x 1 mm
2
cable (DC-
PWR-CAB-1 order code or the pre-fabricated cable with ST-DC-CAB1 order code).