Installation Manual

Chapter 2. Prior to Installation
6
List of Materials, Continued
Powering
materials
The powering materials consist of the following categories:
• Power injectors
• Power cables
• Power modules & connectors
Power injectors
The following table shows the power injectors:
Item Order Code / Photo Description
A
POE-ID-AC75
PoE injector, indoor, -20°C to +40°C, 90
VAC to 264 VAC, 47 Hz to 63 Hz, 75 W.
(AC power cord - EU plug
(1)
is included)
B
POE-IDH-AC56
PoE injector, indoor, temperature hardened,
-40°C to +60°C, 90 VAC to 264 VAC, 47 Hz
to 63 Hz, 56 W.
(AC power cord - EU plug is included)
C
PONE-OD-DC
PonE injector, outdoor, wall mount
(2)
, -50°C
to +65°C,
48 VDC, 60 W (4 x screws and upats, are
included & an M3 grounding screw is pre-
installed on the unit).
D
PONE-OD67-AC
PonE injector, outdoor, wall mount,
temperature hardened, -40°C to +55°C
(operation), 90 VAC to 264 VAC, 47 Hz to 63
Hz, 70 W, IEC 60529 / IP67 class.
Ethernet cable glands and power connector
are included in the unit package. AC power
cable should be ordered separately.
• For wall installation,4 x screws and wall
plugs are included in the unit package.
• For pole installation, a bracket and
accessories (INSTPONE-PL2) should be
ordered.
For grounding requires GND-KIT16-OD (see
page 9)
For powering requires AC-PWR-CAB (see
page 7)
Continued on next page
(1)
Other plug types can be made available upon customer request
(2)
For pole installation, a bracket and accessories (INST-PONE-PL) should be ordered