User's Manual

Table Of Contents
Chapter 3. Installation of StreetNode 6250 PTP
64
Installation of Power Injector (Power over Ethernet), Continued
Mechanical and
cabling
installation
(PonE),
continued
Step Action
3 Prepare and terminate the grounding cable as instructed in
Appendix C: Terminating Grounding cable on page 76
.
Install the grounding cable, as follows:
Use a tamper-proof torx screwdriver T10 to remove the screw
and then install the terminal ring.
Use the tamper-proof torx screwdriver T10 to screw (applying
maximum tightening torque of 0.9 Nm) for securing the cable
in place.
Continued on next page