Instructions / Assembly

12
“OK”
* Metering：
In the setting list, use the UP / DOWN buttons to select “METERING.”, and press “OK
button” to enter setting. There are AVERAGE / SPOT / CENTER. After selection, press “OK button” to
confirm, then press MENU button to return.
“OK”
* Contrast：
In the setting list, use the UP / DOWN buttons to select “CONTRAST”, and press “OK
button” to enter setting. There are STANDARD / HARD / SOFT. After selection, press “OK button” to
confirm, then press MENU button to return.
“OK”
* White Balance: In the setting list, use UP / DOWN buttons to select “WHITE B” , and
press “OK button” to enter setting. There are AUTO / SUNNY/ CLOUDY / TUNGSTEN /
FLUORESCENT / MANUAL. After selection, press “OK button” to confirm, then press
MENU button to return.
When selecting MANUAL white balance mode and exiting menu, monitor will show blinking
manual white balance icon. Aim camera at white balance board and press shutter button to set.
To reset manual white balance again, turn camera on and off to get blinking icon.