User's Manual

※※

I/O DEVICE

9.1 Input/Output Device

Input/Output Control is available from DVR Program [Configuration]

[Event] and it consists of Sensor, (A)ction/Digital Output.

9.2. Channel Selection & Apply All

Select channel after preparation of Input/Output Board and

other Surveillance equipment.

9.3 Sensor Input

[Sensor] is equivalent to Digital Input. When there is input signal

from outside to selected channel(Sensor is activated, e.g.: When

use of fire alarm, sensor is activated when occurrence of fire),

selected channel will recognize as occurrence of event.

All the surveillance equipment is connected to every channel, and

to control all channel, click [Apply All] after setup of [Sensor],

[Action/Digital Output], [Digital Output], [Warning Sound],

[Duration].

9.3.1 NC

[NC] stands for “Normal Close”If this button is selected,

Normally(Event is not occurred) the circuit will be closed. General

Sensors are “Normal Close”but in case of special sensor which is

“Normal Close”type, do not select [NC].

9.3.2 Sensor Port Control

Confirm the video channel of sensor you want to insert, then

click [Enable the Sensor]. Setup the sensor port which is

connected to SmartDVR I/O Board by each channel. Can use

sensor port regardless of digital output number.

9.4 Action//Digital Output

Action//Digital Output - [Enable Event Recording] will automatically record

the image when sensor is activated after an occurrence of event. [Enable

the warning sound] will make a warning sound from the speaker.

※

Annex 1. I/O DEVICE