Operation Manual

(187PO) MODEL ZS8110 OZONE & SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 05/09/2016
187
PO
SAVE THESE INSTRUCTIONS
English
Page 8
SALT & POOL WATER VOLUMES
• Whichkindofsalttouse:
Use only Sodium Chloride Salts
Useonlysodiumchloride(NaCl)saltthatisatleast99.8%pure.Itisalsoacceptabletouse
waterconditioningsaltpellets(thecompressedformsofevaporatedsalt).However,itwilltakea
longer time for them to dissolve.
Do not use iodized or yellow (yellow prussiate of soda) colored salt.
Salt is added to the pool water and the electrolytic cell uses the salt to create chlorine. The purer
the salt the better the performance of the electrolytic cell.
• OptimumSaltLevels
Theidealsaltlevelinthepoolwaterisbetween2500-3500ppm(partspermillion).Theoptimal
level is 3000 ppm.
A too low salt level will reduce the efficiency of the Ozone & Saltwater System and result in
lowchlorineproduction.Ahighsaltlevelmaygenerateasaltytastetothepoolwater(thismay
occuratasaltlevelabove3500-4000ppm).Toohighasaltlevelmaydamagethepower
supply and cause corrosion to the pool metal fixtures and accessories. The Salt Table page of
this manual, shows the correct dosage of salt needed. The salt in the pool is constantly
recycled. The loss of salt is due only to pool water being physically removed from the pool.
Salt is not lost due to evaporation.
• AddingSalt
1
. Switch the filter pump on to start the water circulation.
2
. Keep the Ozone & Saltwater System turned off.
3
. Determinetheamountofsalttobeadded(see“SaltTable”).
4
. Evenly spread the proper amount of salt around the inside perimeter of the pool.
5
. Avoid clogging the filter. Do not add salt through the skimmer.
6
. Brushthepoolbottomtospeedupthedissolvingprocess.Donotallowsalttopileuponthe
bottom of the pool. Run the filter pump 24 consecutive hours to thoroughly dissolve the salt.
7
. After 24 hours and if all the salt is dissolved, turn on the Ozone & Saltwater System, press
button until you hear a “beep”, code “00” flashing and set the saltwater pool system to
 desiredoperatingtime(see“OperatingTimeTable”).
• RemovingSalt
Iftoomuchsalthasbeenadded,theunitwillbeepanddisplay“Code92”(see“AlarmCodes”).
Youwillneedtolowerthesaltconcentration.Theonlywaytodoso,istopartiallydrainthepool
andrefillitwithfreshwater.Drainandrefillapproximately20%ofthepool’swateruntilthe“Code
92” disappears.
• PoolVolumeCalculation
Rectangular
Length x Width x Average Depth x 7.5 Length x Width x Average Depth
Circular
Length x Width x Average Depth x 5.9 Length x Width x Average Depth x 0.79
Oval
Length x Width x Average Depth x 6.0 Length x Width x Average Depth x 0.80
Types of Pool
Gallons
(poolsizeinfeet)
Cubic Meters
(poolsizeinmeters)