Operation Manual

(187PO) MODEL ZS8110 OZONE & SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 05/09/2016

187

SAVE THESE INSTRUCTIONS

English

Page 17

MAINTENANCE (continued)

Flow Sensor Cleaning

. In a counter-clockwise motion unscrew the collar of the flow sensor

(7)

and remove it from

the electrolytic cell conduit. See “Part Reference”.

. If deposits and debris are seen on the surface of the flow sensor, then use a garden hose

to wash it off.

. If flushing with water does not remove the deposits, use a plastic brush to clean the surface

and the hinge if necessary. Do not use a metal brush.

. After the flow sensor has been inspected and cleaned, align the locator notch on the flow

sensor to the connection ridge in the conduit. Now turn the collar in a clockwise motion,

tightening the sensor back into its position. Do not overtighten.

Electrolytic Cell Cleaning

The electrolytic cell has a self cleaning function incorporated into the electronic control's

programming. In most cases this self cleaning action will keep the cell working at optimum

efficiency.Ifthepoolwaterishard(highmineralcontent)thecellmayrequireperiodicmanual

cleaning. To maintain maximum performance, we recommend that you open and visually

inspect the electrolytic cell monthly.

The following steps provide instructions on how to clean your cell.

Inspection and cleaning:

. Switch off the unit, unplug the power cord from the electrical socket.

For filter pumps with 1-1/2” (38mm) hose size -

Turn both plunger valve handles fully

clockwise until they stop. This closes the valve, prevents the water from flowing out of the

pool.

. In a counter-clockwise motion, unscrew the Titanium electrode plug nut. Pull out the

Titanium electrode plug.

Connection Ridge

Locator Notch

Hinge