Operation Manual

(187PO) MODEL ZS8110 OZONE & SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 05/09/2016
187
PO
SAVE THESE INSTRUCTIONS
English
Page 14
7
.
Boost cycle
•
Afteraheavyrainorifthepoolisdirty,pressandhold“BOOST”
button for 5 seconds until the indicator lights up and the
LED display “80”. This indicates that the Ozone & saltwater
system has started ozone and more chlorine sanitizer
 production.Youcanpressandholdthe“BOOST”buttonfor
another 5 seconds until the indicator is off, which will cancel
 theBoostcycle.
•
The boost operating hours is 8 times the amount of time programmed into the system, i.e. if
your Ozone & saltwater system operating time is 3 hours, the boost procedure will run 8 x 3 =
24 hours. After boost procedure has been completed, the system will automatically switch
to the normal working mode.
•
Once the boost is operating, check whether the filter pump operating hours have been set
 properly.Forexample,theboostoperatingtimeis16hours,thefilterpumpshouldbeset
to run for 17 hours at least. Increase the filter pump operating time if necessary.
Note:
If an Intex filter pump is attached to the system, set the pump switch to on “I”
position.
8
.
Test pool water regularly:
Test the pool water every week to maintain the proper sanitizer level.
It’s very important that the free chlorine is between 0.5-3 ppm.
9. Stand-by/power saving mode:
•
When the cycle ends, the green “SLEEP” indicator on the
control panel lights up and the LED display flashes “93”.
 ThesystemisnowinStand-Bymode.Afterawhile,it  
shuts down and sets itself in a Power Saving mode. The
system will automatically turn itself back on in 24 hours,
starting its daily cycle of chlorine production.
•
The “SLEEP” indicator stays on, while the system is in the
Power Saving mode. The LED display however, goes blank
 after5minutes.Pressanybutton(or)toviewthelast
LED code.
OPERATION INSTRUCTIONS (continued)