Operation Manual

254
PO
S AVE THESE INSTRUCTIONS
(254PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 08/31/2018
English
Page 9
SET UP
(continued)
5.
Press the button to turn on the control unit panel buttons fi rst.
Press the button to infl ate the spa tub wall for 8 to 10 minutes
until it is fi rm to the touch but not hard
(see drawing 6)
.
IMPORTANT:
Do not over infl ate or use high pressure air
compressor to infl ate.
6.
Press the button again to turn it off.
7.
Replace the air valve cap back.
NOTE:
The cap is designed to be screwed on and off. Never exert
force as this could cause the complete internal infl ation system of the
valve to come loose. See “Spa Tub Air Valve Fastening” for valve
maintenance.
Infl ate the Spa Cover Air Bladder
1.
Open the infl ation valve and insert the infl ation hose
(7)
into the
valve; press to infl ate until it is fi rm to the touch but not hard
(see drawing 7)
.
2.
Disconnect the infl ation hose
(7)
from the air blower infl ation outlet
and the valve.
3.
Replace the control base infl ation cap
(5)
back; close and recess the
infl ation valve.
NOTE:
If there is a need to add some air to the spa tub wall or spa cover
air bladder after they have been setup, refer to above “Infl ate the Spa Tub Wall” and “Infl ate the Spa Cover
Air Bladder” sections. The cover air bladder is preinstalled inside the spa cover. If it needs to be reinstalled,
place the uninfl ated air bladder inside the spa cover lip before infl ating the bladder.
Defl ation
For Spa Tub Wall:
1.
Unscrew the cap to reveal the stem, push the stem in and turn 90
degree right to secure it in the down position
(see drawing 8)
.
2.
Once the defl ation is completed, push the stem in and turn 90 degree
left to return it to the infl ation position.
3.
Replace the cap back.
For Cover Air Bladder:
1.
Pull valve cap out and squeeze the valve at its base until defl ated.
2.
Close and recess the valve back.
7
7
6
8
2.
Press the button located on top of the control base and remove the back cover
(see drawing 3)
.
3.
Unscrew the control base infl ation cap
(5)
to reveal the air blower infl ation outlet, insert one end of the
infl ation hose
(7)
into the outlet and turn to the right to lock it
(see drawing 4)
.
4.
Unscrew the air valve cap to reveal the stem in the up position for infl ation. Insert the other end of the
infl ation hose
(7)
into the valve and turn to the right to lock it in position
(see drawing 5)
.
3
Press
4
5
7
5
7
1 2