Operation Manual

(110) MODEL 634 FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 08/21/2012
110A
SAVE THESE INSTRUCTIONS
Page 10
English
SETUP INSTRUCTIONS
FILTER PUMP STATIONARY MOUNTING
Some countries, especially in the European community, require the filter-pump to
be secured to the ground or to a base in a permanent upright position. Check your
local authorities to determine if there is a regulation in your area regarding
above-the-ground swimming pool filter-pumps. If yes, then the filter-pump can be
mounted to a platform using the two holes located in the base. See drawing below.
The filter-pump can be mounted on a cement base or onto a wooden platform to
prevent accidental falling over. Total assembly must exceed 18kg.
165 mm
1. The mounting holes are 6.4 mm in diameter and spaced 165 mm apart.
2. Use two bolts and lock nuts with a maximum of 6.4 mm in diameter.
FILTER PUMP INSTALLATION DISTANCE
(Generic layout of an electrical device relative to a swimming pool. Illustration not to
scale)
According to the International Standard, IEC 60364-7-702, on electrical installation
of swimming pools and other basins equipments, the following installation distances
must be respected:
• The filter pump must be position more than 2m away from the pool walls.
• The power cord plug to the 220-240 volt electrical power source of the filter
pump must be position more than 3.5 m away from the pool walls.
Check your local authorities to determine the appropriate standard and
requirements for “electrical installation of swimming pools and basins equipments”.
The following table is for reference only:
International
France
Germany
The Netherlands
Country/Region
Standard Number
IEC 60364-7-702
NF C 15-100-7-702
DIN VDE 0100-702
NEN 1010-702
>2m
>3.5m
POOL
hoses
Electrical
device