Operation Manual

(260PO) MODEL ECO7110&8110 SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 06/29/2016
260
PO
SAVE THESE INSTRUCTIONS
English
Page 20
LED CODE CHART
IMPORTANT
When Code “90” alarm is shown, ensure the timer of the filter pump is set
one (1) hour longer than the Saltwater System.
If the filter pump does not have a built-in timer, the filter pump needs to
be turned on/off manually every day.
LED Reading Definitions
80 BoostMode
 00 Stand-ByMode(Start-up)
 01 MinimumOperatingHour(1hourremaining)
 02 OperatingHours(2hoursremaining)
 03 OperatingHours(3hoursremaining)
 04 OperatingHours(4hoursremaining)
 05 OperatingHours(5hoursremaining)
 06 OperatingHours(6hoursremaining)
 07 OperatingHours(7hoursremaining)
 08 OperatingHours(8hoursremaining)
 09 OperatingHours(9hoursremaining)
 10 OperatingHours(10hoursremaining)
 11 OperatingHours(11hoursremaining)
 12 MaximumOperatingHours(12hoursremaining)
 90 AlarmCode(LowPumpFlow/NoPumpFlow)
 91 AlarmCode(LowSaltLevel)
 92 AlarmCode(HighSaltLevel)
 93 Stand-ByMode(OperatingProcessfinished)
 “BLANK” NoPoweror“PowerSavingMode”waitingtostartnext
Saltwater System cycle.