Operation Manual

86PO
S AVE THESE INSTRUCTIONS
(86PO) EASY SET POOL ENGLISH 7.5” X 10.3” PANTONE 295U 05/17/2016
English
Page 12
POOL SETUP (continued)
2
3
IMPORTANT
Properinationofthetopring.
The ambient temperatures of air and water have an effect on the internal pressure of the top ring. To
maintain a correct internal pressure, it is best to leave some room for expansion as the sun heats the
air inside the ring. During very hot weather, you must check to see whether it is necessary to release
some air. This is to avoid any possible damage to the ring.
In no event shall Intex, their authorized agents or employees be liable for damages (such as pin
holes) to the inatable top ring caused by negligence, ordinary wear and tear, abuse and
carelessness, or external forces.
YoumayhavepurchasedthispoolwiththeIntexKrystalClear™lterpump.Thepumphasits
ownseparatesetofinstallationinstructions.Firstassembleyourpoolunitandthensetupthelter
pump.
Estimatedassemblytime10~30minutes.(Notetheassemblytimeisonlyapproximateand
individualassemblyexperiencemayvary.)
1. Liner preparation
•
Findaat,levellocationthatisfreeandclearofstones,branchesorothersharpobjectsthatmay
puncture the pool liner or cause injury.
• Openthecartoncontainingtheliner,etc.,verycarefullyasthiscartoncanbeusedtostorethepoolduring
the winter months or when not in use.
• Takeoutthegroundcloth
(3)
and spread it over the cleared area.
Then take out the liner
(1)
and spread it out over the ground cloth,
with the drain valve directed towards the draining area. Place the
drain valve away from the house.
IMPORTANT: Always set up the pool unit with at least 2
persons. Do not drag the liner across the ground as this can
cause liner damage and pool leakage (see drawing 2).
• Duringthesetupofthepoolliner,pointthehoseconnectionsor
openings in the direction of the electrical power source. The
 outeredgeofthepoolshouldbewithinreachofthepump’s
electrical connection.
• Layoutthepool.Spreadouttheplainbluesidesandmakethe
 pooloorassmoothaspossible
(see drawing 2).
2. Ring ination
• Flipthetopringoutandcheckthatitisfullyoutsideofthewall
 liningandfacingup.Inatetheringwithamanualairpump
(see
drawing 3)
.Keepthetopringcenteredinthemiddleofthepool,
while doing this.
IMPORTANT: Prevent bursting by not using a high-pressure
pump, such as an air compressor. Do not over inate.
Preferably use an Intex manual ination hand pump
(not included).
3. Hose connectors
• Thefollowingappliestopoolliners
with
hoseconnectors(16"(488cm)&belowpools).Ifthepoolwas 
purchased
without
alterpump,inserttwoblackplugs
(2)
intotheblacklterpumpoutlets.Dothis
 fromtheinsideofthepoolsothatwaterwillnotrunoutwhenllingit.
• Ifthepoolwaspurchased
with
alterpump,readtheKrystalClear™FilterPumpManualrstand
then
proceed to next installation step.
1
WATER
LEVEL
Level
FILL LINE