Owner's Manual

(20PO) AP619DA ELECTRIC PUMP ENGLISH 4.875” X 7.25” 08/25/2022
20
PO
READ AND SAVE THESE INSTRUCTIONS
Page 5
1. Touch the menu icon on the top right corner and select language to change the App
control interface language. See Fig A.
2. A blue Bluetooth icon means a successful connection, while a red icon means a failed
connection. See Fig A - B. Refer to the “App Troubleshooting” section for details.
• INFLATE (
): Touch this button to activate the inflation function.
When the inflation is completed, touch the “
” button to stop the pump.
• STOP (
): Touch this button to stop the pump at any time.
• ADJUST (
): Touch this button to release a small and short amount of air at a
time.
• DEFLATE (
): Touch this button to activate the deflation function. When the
deflation is completed, touch the “ ” button to stop the pump.
disconnect
INFLATE
STOP
ADJUST
DEFLATE
BK3633
INFLATE
STOP
ADJUST
DEFLATE
FIG A.
Menu
Blue
FIG B.
disconnect
INFLATE
STOP
ADJUST
DEFLATE
BK3633
INFLATE
STOP
ADJUST
DEFLATE
Red
APP QR Code
Intex
®
Air Mattress Remote App Setup User Guide
The App allows you to operate and control the electric air pump via Bluetooth
from a mobile device. Follow below steps to install and use the App:
1) Activate the Bluetooth function on the mobile device and ensure the air pump is plugged
into an electrical outlet and the interface panel light is on. NOTE: Keep the mobile
device within 5m (16ft) range of the air bed to ensure good signal and connectivity.
2) Scan the App QR code located on the pump panel or on this manual to install the App.
You may also download the “Intex Air Mattress Remote App” from your App store.
3) Open the App and select the air bed to be connected from the “Add Product” list. Tap
on the air bed name to rename it for easy identification. You can only connect to one air
bed at a time.
NOTE: On mobile devices with older operating system, you may be prompted to allow
the App to access your device’s location and information. If so, please allow the app
to access the location and information of the device in order to achieve a successful
connection between the device and the electric air pump of the air bed.
4) App control interface operation: