Operation Manual

ManualsBrandsIntex ManualsMiscellaneous8110 Krystal Clear de luxe

101

SAVE THESE INSTRUCTIONS

Page 19

(101) MODEL 8110 KRYSTAL CLEAR™ DELUXE SALTWATER SYSTEM (SALT IN POOL) ENGLISH 7.5” X 10.3” PANTONE 295U 08/07/2008

ALARM CODES

No chlorine production will occur if “Low Water Flow”, “Low Salt Level” or “High Salt

Level” are detected. If any of these conditions occur then the Saltwater System will

sound an alarm that indicates chlorine production has stopped. A buzzer will sound

and a Code (see below) will keep flashing on the LED for 1 hour. The buzzer and

flashing light will end after one hour and the Saltwater System will go to Power

Saving Mode. If this occurs then press any button ( or ) to view the code of

the original problem so that it can be corrected.

Turn off the power of the unit and follow the solutions below to solve the problem.

Turn on the unit again by following the “Operating Instructions”.

AALLAARRMMSS

English

Code Cause Remedy Flashing Buzzer

1. Circulation line

blocked.

2. Incorrect inlet and

outlet hose

direction.

3. Flow sensor

conduit incorrectly

installed.

4. Scale on the flow

sensor.

5. Flow sensor cord

is loose.

6. Flow sensor failure.

1. Dirt or scale on

titanium plates.

2. Low salt level / No

salt.

3. Electrolytic cell

cord is loose.

4. Possible electrolytic

cell failure.

1. High salt level.

• Ensure the plunger valves are

opened (if any).

• Ensure your filter cartridge, cell are

clear from debris and dirt. See

“Maintenance”.

• Release all trapped air in the

circulation line. See Filter Pump

Manual.

• Check for the direction of water

inlet and water outlet hose. Reverse

the hoses if necessary. See “Set

Up Instructions”.

• Check for the arrow on the follow

sensor conduit toward the same

direction with the one on the cell.

Reverse the follow sensor conduit if

necessary.

•

Ensure the flow sensor (especially

the hinge) is clean. See “Maintenance”.

• Check for flow sensor loose or not

connected properly. Plug the flow

sensor firmly into the flow sensor

receptacle.

• Contact Intex Service Center for

replacement.

• Remove the electrolytic cell for

inspection and clean it if necessary.

See “Maintenance”.

• Add salt. See “Salt & Pool Water

Volumes”.

• Check to see if cell cord is loose or

not connected properly. Ensure the

cell cord is plugged firmly into the

cell housing receptacle.

• Contact Intex Service Center.

Replace the cell if needed.

• Partially drain the pool and refill

with fresh water. See “Salt & Pool

Water Volumes”.

Low

Water

Flow or

No Flow

Low Salt

Level

High Salt

Level

Ye s