Operation Manual

101
SAVE THESE INSTRUCTIONS
Page 18
(101) MODEL 8110 KRYSTAL CLEAR™ DELUXE SALTWATER SYSTEM (SALT IN POOL) ENGLISH 7.5” X 10.3” PANTONE 295U 08/07/2008
English
OPERATION INSTRUCTIONS (continued)
OOPPEERRAATTIINNGG IINNSSTTRRUUCCTTIIOONNSS
5. Operating hours can be re-adjusted if necessary. Follow steps 2 thru 4.
6. The scheduled operating hours displayed on the LED readout will decrease to
zero as the unit operates. The LED shows “hours remaining” in the daily
operating cycle.
7. The green “SLEEP” light on the control panel will appear when
the cycle has ended. The system will go into a “Stand-By
Mode” with the LED flashing “93” and “SLEEP” light on. The
system automatically goes into a “Power Saving Mode” and will
automatically turn itself back on in 24 hours to continue its daily
chlorine production.
8. The “SLEEP” light will keep on, but the LED will be become
blank after 1 hour indicating the Saltwater System is dormant
(Power Saving Mode) waiting for the next startup cycle to begin.
Press any button ( or ) to view the last LED code.
SPECIAL NOTES
• Always use a test strip to test the chlorine level before entering or using the
pool. If the chlorine level is too high, wait until the chlorine level drops
below 3 ppm before using the pool or operating the Saltwater System
again.
• Heavy pool usage, and higher temperatures may require higher chlorine output
(longer operation time) to maintain proper free available chlorine residuals.
• If a power outage occurs or the power cord is unplugged then the Saltwater
System operating hours will have to be reset.
IMPORTANT
Never use the pool if chlorine level is more than 3 ppm. Do not operate
Saltwater System while the pool is in use or occupied.