Operation Manual

(106) MODEL 638R FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 07/24/2012

106A

SAVE THESE INSTRUCTIONS

Page 8

English

SETUP INSTRUCTIONS

FILTER PUMP STATIONARY MOUNTING OPTION

-- (3) x M6 HEXAGON HEAD BOLTS

-- (3) x M6 HEXAGON LOCK-NUTS

145mm

There are three mounting holes located at the bottom of the filterpump base.

These holes are provided because various country’s regulations, especially in the

European community, require the filterpump to be secured to the ground or to a

base in a permanent upright position.

These three holes form a triangle pattern and are 145mm from each other. The

holes are slotted with a 7mm width.

The filterpump can be mounted on a cement base or onto a wooden structure to

prevent accidental falling over. Total assembly must exceed 18kg. The drawings on

the following show two possible ways of upright mounting.