Operation Manual

58GS

SAVE THESE INSTRUCTIONS

(58GS) MODEL 604G FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/04/2016

English

Page 7

FILTER PUMP STATIONARY MOUNTING OPTION

-- (3) x M6 HEXAGON HEAD BOLTS

-- (3) x M6 HEXAGON LOCK-NUTS

135mm

There are three mounting holes located at the bottom of the filter pump base. These holes are

provided because various country’s regulations, especially in the European community, require

the filter pump to be secured to the ground or to a base in a permanent upright position.

These three holes form a triangle pattern and are 135mm from each other. The holes are slotted

with a 7mm width.

The filter pump can be mounted on a cement base or onto a wooden structure to prevent

accidental falling over. Total assembly must exceed 18kg. The drawings on the following show

two possible ways of upright mounting.

SETTING UP FILTER PUMP

For your own personal safety, it is very important that you place your transformer more than 3.5m

away from your pump.

3.5 m