Operation Manual

(57) MODEL 603 FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 08/06/2012
57
SAVE THESE INSTRUCTIONS
Page 9
English
TROUBLESHOOTING GUIDE
TROUBLESHOOTING GUIDE
• Filtercordmustbepluggedintoa3
wire outlet that is protected by a Class
AGroundFaultCircuitInterrupter.
• Resetcircuitbreaker.Ifcircuitbreaker
trips repeatedly, your electrical system
may have a defect. Turn off circuit
breaker and call an electrician to
correct the problem.
• Letmotorcooldown.
• AdjustthechlorineandpHlevel.Consult
your local swimming pool supply stores.
• Cleanorreplacecartridge.
•
Check the cartridge for holes.
Replace if
damaged.
• Operatethefilterforlongerperiods.
• Cleanthestrainerscreenattheinlet.
• Clearanyobstructionsintheintake
hose by discharging it inside pool wall.
• Tightenhoseclamps,checkhosesfor
damage, check pool water level.
• Replacecartridge.
• Cleancartridgemoreoften.
• Installthenozzleattheupperposition
of the pool inlet, and the strainer at the
lower position of the pool outlet.
• Fillpooltocorrectwaterlevel.
• Cleanstrainerscreensatpoolinlet.
• Tightenhoseclamps,checkhosefor
damage.
• Clearanysticksorleavesinthe
intake hose.
• Openthereleasevalveattopofpump.
• Removecover&checkforO-ring.
• Tightencover(Manually).
• Replaceorcleancartridge.
• Tightenorreinstallhoseclamps.
• Openairreleasevalve,liftandlower
the inlet hose until water starts to flow
out of air release valve, close air
release valve.
FILTER MOTOR
FAILS TO START
FILTER DOESN’T
CLEAN POOL
FILTER DOESN’T
PUMP WATER OR
FLOW IS VERY
SLOW
PUMP DOESN’T
WORK
TOP COVER
LEAKING
HOSELEAKING
AIRLOCK
• Themotorisnotpluggedin.
• Thefuseboxneedschecking.
• TheGFCIcircuitbreakeris
tripped.
• Motortoohotandoverload
protection is shut off.
• ImproperchlorineorpH
levels.
• Filtercartridgeisdirty.
• Damagedcartridge.
• Excessivelydirtypool.
• Thestrainerscreenis
restricting the water flow.
• Cloggedinletordischarge.
• Anairleakontheintakeline.
• Scaleorbuilduponcartridge.
• Excessivelydirtypool.
• Dirtyfiltercartridge.
• Nozzleandstrainer
connection are reversed.
• Lowwaterlevel.
• Strainerscreenpluggedup.
• Anairleakontheintakehose.
• Faultymotorortheimpeller
is jammed.
• Anairlockinsidethecartridge
chamber.
• O-ringmissing.
• Coverisnottight.
• Filtercartridgeisdirty.
• Hoseclampsarenot
well-fitted.
• There’sairtrappedinthe
pump housing and inlet hose.
TROUBLE
CAUSE
SOLUTION