User Manual
(155PO) POOL LIGHT ENGLISH 7.5” X 9.25” PANTONE 295U 08/18/2015
English
SAVE THESE INSTRUCTIONS
155
PO
Page 7
IMPORTANT
If you continue to experience diffi culty, please contact our Consumer Service Department for
assistance. See separate “Authorized Service Centers” sheet.
TROUBLE SHOOTING GUIDE
LONG TERM STORAGE
In areas where freezing temperatures occur, there is risk of ice damage to the product. It
is recommended to remove, clean and store the product in a safe place when temperature
drops below 0 degrees Celsius (32 degrees Fahrenheit).
1
. Unplug the power cord from the electrical socket.
2.
Remove the transmitter
(2)
from the outside of the pool wall fi rst, the pool light
(1)
unit will
automatically fl oat to the surface for easy retrieval, then remove the pool light from the water.
IMPORTANT: To prevent damage to the transmitter from falling to the ground, always
remove the transmitter fi rst before removing the pool light unit.
3
. If deposits or debris are seen inside the holes of the pool light, use a garden hose to fl ush them
out. Do not scrape the pool-wall light or use brush to clean it.
4.
Thoroughly air-dry all components before storage.
5.
Store the product and accessories in a dry, temperature controlled location between 32 degrees
Fahrenheit (0 degrees Celsius) and 104 degrees Fahrenheit (40 degrees Celsius).
6
. The original packaging can be used for storage.
• Rearrange the orientation of the pool light
and the transmitter. See “setup instructions”.
• Contact Intex Service Center.
• Contact Intex Service Center.
• Contact Intex Service Center.
DIFFICULT TO ALIGN
THE POOL LIGHT AND
THE TRANSMITTER
THE LED
POOL-WALL LIGHT
DOES NOT LIGHT UP
• Wrong orientation, magnetic poles
are not aligned correctly.
• The power cord is loose.
• Wrong orientation and alignment
between the pool light and the
transmitter.
• Water inside pool light unit.
• Possible transmitter or transformer
failure.
• Water inside the pool light unit.
PROBLEM CAUSE SOLUTION
• Plug the cord fi rmly into the electrical outlet.
• Tighten the intermediate connection
between the transmitter and the transformer.
• The GFCI is tripped.
• Rearrange the orientation of the pool light
and the transmitter. See “setup instructions”.
THE POOL LIGHT UNIT
DOES NOT FLOAT