User Manual

254
PO
S AVE THESE INSTRUCTIONS
(254PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 05/29/2015
English
Page 9
SET UP
(continued)
5.
Press the button to turn on the control unit panel buttons rst. Press the button to inate the
spa tub wall until it is rm to the touch but not hard
(see drawing 6)
.
IMPORTANT:
Do not over inate or use high pressure air compressor to inate.
6.
Press the button again to turn it off.
7.
Disconnect the ination hose
(7)
from the air valve and attach the pressure gauge
(23)
to the air valve.
The pressure gauge indicator should be in the green area for a properly inated spa tub
(see
drawing 7)
. Repeat previous steps to add more air if necessary.
8.
Replace the air valve cap back.
NOTE:
The cap is designed to be screwed on and off. Never exert force as this could cause the
complete internal ination system of the valve to come loose. See “Spa Tub Air Valve Fastening” for
valve maintenance.
Inate the Spa Cover Air Bladder
1.
Open the ination valve and insert the ination
hose
(7)
into the valve; press to inate
until it is rm to the touch but not hard
(see
drawing 8).
2.
Disconnect the ination hose
(7)
from the air
blower ination outlet and the valve.
3.
Replace the control base ination cap
(5)
back;
close and recess the ination valve.
NOTE:
If there is a need to add some air to the spa tub wall or spa cover air bladder after they have been
setup, refer to above “Inate the Spa Tub Wall” and “Inate the Spa Cover Air Bladder” sections. The cover
air bladder is preinstalled inside the spa cover. If it needs to be reinstalled, place the uninated air bladder
inside the spa cover lip before inating the bladder.
Deation
For Spa Tub Wall:
1.
Unscrew the cap to reveal the stem, push the stem
in and turn 90 degree right to secure it in the down
position
(see drawing 9).
2.
Once the deation is completed, push the stem in
and turn 90 degree left to return it to the ination
position.
3.
Replace the cap back.
For Cover Air Bladder:
1.
Pull valve cap out and squeeze the valve at its base
until deated.
2.
Close and recess the valve back.
9
104
F
o
104
F
o
104
F
o
8
7
6 7
23
104
F
o
1
2