Operation Manual

119
PO
SAVE THESE INSTRUCTIONS
(119PO) ULTRA XTR™ RECTANGULAR / PRISM FRAME™ POOLS ENGLISH 7.5” X 10.3” PANTONE 295U 11/07/2018
English
Page 13
POOL SETUP (continued)
5.
ThetopsoftheU-shapedsidesupportshaveadouble
button spring loaded clip
(10) that is factory pre-installed.
Insertthesidesupportsintothe“A-B-C&D-E-F”beam
holesbysqueezingthebottombuttoninwardwithyour
fingers.
Squeezingthisbottombuttonwillallowthesupporttoenter
the beam. Once the U-support is inside the beam release
thefingerpressureallowingthesupportto“SNAP”into
place. Repeat this procedure for all U-shaped side supports
(see drawing 5).
6.
Withonepersonstandinginsidethepool,raiseonecorner;
insert the connecting rod
(12)
intotheoverlappingopenings,
to connect the liner straps to the restrainer straps. Repeat
the operation in the other corners and then
on the sides
(see drawings 6.1 & 6.2).
7.
Pull the bottoms of the side supports out away from the
liner to make the straps taut. Repeat for all locations
(see drawing 7)
.
8.
Ifthegroundisnotconcrete(asphalt,lawnorearth)you
mustplaceapieceofpressure-treatedwood,size
15”x15”x1.2”,undereachlegandflushwiththeground.
The U-shaped side supports must be placed in the center
of the pressure-treated wood and with the wood grain
perpendicular to the support leg
(see drawing 8).
5
13
11
10
6.1
6.2
LINER
LINER
12
7
12
8
Level