Use and Care Manual

315
PO
SAVE THESE INSTRUCTIONS
English
(315PO) Prism Frame™ Premium Pool / Greywood Prism Frame™ Premium Pool ENGLISH 7.5” X 10.3” PANTONE 295U 10/14/2019
Page 15
POOL SETUP (continued)
The last joint connection may be difficult to complete. You can
do it though, if you first simultaneously raise the last joint and
beam about 2 inches (5 cm). Now insert the beam into the joint
while lowering the pieces into position. The beam will easily
slide into the joint (see drawing 2.3). Ensure that the last joint
is fully connected before proceeding to connecting the legs.
3. Vertical legs assembly
• Attachtheleg’sendcap
(3) to the bottom of each leg (2)
first.With
the beams and T-joints assembly resting on the ground, slide one
 verticallegintothebeltlooplocatedinthemiddleofthepoolliner
and insert the top of the leg into the bottom of the T-joint
(1) (see
drawing 3.1)
.Continuetheprocesswithalltheverticallegs.
• Liftthebeamsassemblyandmakesureallthelegsareinavertical
position
(see drawing 3.2). Push all the T-joints downward to
ensure they are firmly connected to the legs.
• Pullgently,inanoutwarddirection,thebottomofthelegmakingsure
 thelegisverticalandperpendiculartothelevelground.
4. Filling of the pool
• Thefollowingappliestopoolliners
with
hoseconnectors(16’(488cm)&belowpools).Ifthepoolwas 
purchased
without a filter pump, insert the strainer hole plugs (8)
intotheblackfilterpumpoutlets.Do 
this from the inside of the pool so that water will not run out when filling it. If the pool was purchased
with
 afilterpump,readtheKrystalClear™FilterPumpManualfirstand
then proceed to next installation step.
• Beforefillingthepoolwithwater,ensurethatthedrainpluginsidethepoolisclosedandthatthedrain 
 capontheoutsideisscrewedontightly.Fillthepoolwithnomorethan1inch(2.5cm)ofwater.Check 
 toseewhetherthewaterislevel.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely level. Setting
up the pool on unlevel ground will cause the pool to tilt resulting in the sidewall material bulging
and a potential collapse of the pool. If the pool is not completely level, you must drain the pool,
level the area or move the pool to a different area that is level, and re-fill the pool, following the
above directions.
• Smoothoutthebottomlinerwrinkles(frominsidethepool)bypushingoutwherethepoolfloorandpool
 sidesmeet.Or,(fromoutsidepool)reachunderthesideofthepool,graspthepoolfloorandpullinan
 outwarddirection.Ifthegroundclothiscausingthewrinkles,have2peoplepullfromoppositesidesto 
 removeallwrinkles.Usetheproperlyassembledpoolladderwhenenteringorexitingthepoolduringthis
 process.Alsomakesureallthelegsareverticalandperpendiculartotheground.
• Fillthepoolwithwateruptojustbelowthesleeveline
(see drawing 4).
5
.
Posting aquatic safety signs
 SelectahighlyvisibleareanearthepooltoposttheDanger
 NoDivingorJumpingsignincludedlaterinthismanual.
3.2
2
3
3.1
2
3
3
2.3
1
4
WATERLEVEL