User guide

(118PO) ULTRA FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 07/20/2012
118
PO
SAVE THESE INSTRUCTIONS
Page 7
English
SETUP INSTRUCTIONS
POOL SETUP (continued)
YoumayhavepurchasedthispoolwiththeIntexKrystalClear™filterpump.Thepumphas
its own separate set of installation instructions. First assemble your pool unit and then set up
the filter pump.
Estimatedassemblytime45-60min.(Notetheassemblytimeisonlyapproximateand
individual assembly experience may vary.)
1. Liner preparation
• Findaflat,levellocationthatisfreeandclearofstones,branchesorothersharpobjects
that may puncture the pool liner or cause injury.
• Openthecartoncontainingtheliner,joints,legs,etc.,verycarefullyasthiscartoncanbe
used to store the pool during the winter
months or when not in use.
• Takeoutthegroundcloth(7) (optional) 
and spread it over the cleared area. Then,
take out the liner (5) and spread it out over
the ground cloth, with the drain valve directed
towards the draining area. Place the drain
valve away from the house. Allow the sun to
warm up the liner before inserting the beams (4) into the sleeve openings.
IMPORTANT: Always set up the pool
unit with at least 2 persons. Do not drag the liner across the ground as this can
 causelinerdamageandpoolleakage(seedrawing1).
• Duringthesetupofthispoolliner,pointthehoseconnectionsoropeningsinthe
direction of the electric power source. The outer edge of the pool should be within reach
 ofthepump’selectricalconnection.
2. Frame assembly
• Theframepool’slegs(2) and beams (4) fall into two
groups. The smaller diameters are the vertical legs. Both
these legs and beams fit into the T-joints (1).
• Startingatanylocation,butalwaysworkinginthe
 samedirection,pushthehorizontalbeamintothe
sleeve (see drawing 2.1). Once the beam is centered
take one of the T- joints (1), snap the joint to one end
of the beam by aligning the hole and the spring-loaded
pin. Repeat this procedure in a circular fashion until all
the beams and joints have been connected
(see drawing 2.2).
The last joint connection may be difficult to complete,
but can be easily done by simultaneously raising this
last joint and beam more than 2 inches (5 cm), and
connect the beam to the joint while lowering these
pieces to their normal position. The joint will slide into
 thebeam(seedrawing2.3).Makesurethelastjointis
fully assembled before proceeding to assembling the
legs.
1
5
2.1
2.3
1
2.2